SokilLink R1

COMING SOON

USD $500
(2 modules + camera set)

HD FPV System with extended capabilities which allows to stream FullHD low-latency video over WiFi or 4G, control unmanned vehicle using with gamepad or GCS software and observe all telemetry in real time

Request quote

Description

SokilLink R1 is a set of Single Board PCs (on-board and ground one) equipped with a camera.


It establishes data link using built-in 2x2 MIMO dual-band WiFi modules which is used for video, telemetry and RC gamepad commands streaming.
For high-range usage scenarios, it is possible to use either 4G or high-power WiFi modules.
On the ground side, it is possible to use a smartphone, tablet or laptop with your favorite GCS for control and video playback.

Features

  • FullHD video streaming with ~100ms latency
  • Video output to smartphone or display with HDMI
  • Multiple USB/IP cameras support
  • Transparent IP link
  • miniPCIe port for high-range WiFi or 4G module
  • Two-way telemetry exchange
  • Manual control using USB gamepad
  • Highly customizable

Technical specifications

General

EIRP21dBm
Operating frequency2.4GHz/5GHz
Supported autopilotsArduPilot 4.0+, PX4 1.8+

R1 module

Antenna connector2 x u.FL
Dimensions35x70mm
Weight28g
Operating temperature0-40°C
Operating voltage6 - 28V
Operating current500mA @ 12V
Interfaces1 x miniPCIe, 3 x USB, 1 x UART, 1 x Ethernet

Camera

Video resolution1080p30
Video latency100 - 160ms
Typical video bitrate8Mbit/s
Focal length2.1mm
InterfaceUSB
Dimensions38x25x17mm
Weight18g
Operating temperature0-40°C

Camera

High-quality low-latency FullHD camera allows to pilot your drone without any trade-offs. While its dimensions make it possible to mount it even on a small vehicle.

Besides good normal light performance it also can operate in low light conditions.

Customization

We spend lot of time making all these features highly customizable. There is a configurator application which allows to conffigure Mavlink routing, video streaming, cameras control and much more. You can also monitor systems health in order to be sure that everything works well.

Another huge feature which would be useful for developers is a possibility to monitor all Mavlink traffic passing through specific interface.

Learn more at the solution page